Kepco MST 488 Programmer Manuel d'utilisateur télécharger pdf (Page 45)

MST488-27 013004

A-3

A.8 *OPC? — OPERATION COMPLETE QUERY

*OPC?

Syntax: *OPC?

Return value: <1> (ASCII) placed in output queue when power supply has completed operation.

Description: Indicates when pending operations have been completed.When all pending operations are com-

plete (all previous commands have been executed and changes in output level have been completed)

a “1” is placed in the Output Queue. Subsequent commands are inhibited until the pending operations

are completed. *OPC? is intended to be used at the end of a command line so that the application pro-

gram can monitor the bus for data until it receives the “1” from the power supply Output Queue. (See

example, Figure A-1.)

A.9 *OPT? — OPTIONS QUERY

*OPT?

Syntax: *OPT?

Returns string determined by power supply model.

Description: Causes the power supply to return an ASCII string which defines the functionality of the power

supply. The functionality is defined as follows:

FIGURE A-1. GPIB COMMANDS

STRING DATA MEANING

RI1

Indicates unit has the ability to modify the DCL response.

CHN

Indicates multiple channel device is enabled

DS0

Display present, no text capability.

CIIL

Unit supports CIIL commands

*CLS Power supply clears status data.

*ESE 60 Power supply enables bits 5, 4, 3 and 2, allowing command error, execution

error, device dependent error and query error to set the Event Status

Summary bit when an STB command is executed.

*ESE? Returns 60, (value of the mask) verifying that bits 5, 4, 3 and 2 are enabled.

*ES Unknown command will set command error (Bit 5).

*ESR? Returns 32 (bit 5 set), indicating Command Error has occurred since the last

time the register was read.

*IDN? Controller returns character string: "KEPCO,MST,1,V3.0-3.0"

*OPC Allows status bit 0 to be set when pending operations complete

VOLT 21;CURR 3 Sets output voltage to 21V, output current to 3A

*ESR Returns 129 (128 + 1, power on, bit 7 = 1, operation complete, bit 1 = 1)

*ESR Returns 0 (event status register cleared by prior *ESR?)

VOLT 15;CURR 5;*OPC? Sets output voltage to 15V, output current to 5A, puts “1” on output bus when

command operations are complete.

*RST Power supply reset to power on default state.

*SRE 40 When ESB or QUES bits are set (Table A-3), the Request for Service bit will

be set.

*SRE? Returns the value of the mask (40).

*STB? For example, the Power supply responds with 96 (64 + 32) if MSS and the

Event Status Byte (Table A-3) summary bit have been set. The power supply

returns 00 if no bits have been set.

VOLT 25 Power supply voltage commanded to 25V.

VOLT:TRIG 12 Programs power supply voltage to 12V when *TRG received.

INIT Trigger event is initialized.

*TRG Power supply reverts to commanded output voltage of 12V.

*TST? Power supply executes self test and responds with 0 if test completed

successfully, with 1 if test failed.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

Kepco MST 488 Programmer Manuel d'utilisateur Page 45

Commentaires sur ces manuels

Produits connexes et manuels pour Fournisseurs d'énergie Kepco MST 488 Programmer